Remote output failure

Barry Isseks

I run a flex 6400 current v3239 software remote. Now about every 2nd connection I get no power output on tune. Ssb shows modulation but no power out. CW DOES have output power in tune. To fix this I need to reboot the radio remotely. It works as long as I am active but next day it might happen again if radio left on…. Any explanations out there??? Thanks

David Decoons, wo2x

Hi Barry,

latest version SmartSDR is 3.3.33 and 3.4 is not far away. You can try 3.3.33 to see if it helps.

Dave wo2x

Barry Isseks

I have the same issue with IOS access, so it seems software independent.

David Decoons, wo2x

But if you are using 3.2.39 then radio has 3.2.39 loaded.

you need to load 3.3.33 from PC to upgrade radio. And follow the release notes instructions.

Dave

David Decoons, wo2x

Here’s the release notes

https://edge.flexradio.com/www/uploads/20221004102529/SmartSDR_v3.3.33-Release-Notes.pdf

Dave wo2x

Barry Isseks

Ok… I get it… I’ll do that update and see what happens.

Kurt Zwerger

Were you able to fix the issue with the power. I have the same problem. Thanks....73 de IN3DOV