Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Is the PA in the 6400M common to HF bands & 6 meter band

joep
joep Member ✭✭
edited June 2022 in Third-Party Software
Getting full power on HF but only 55w on 6 meters running FT8 (50.313) VSWR is 1.65
TX band setting is 100w.
Any other settings to check ?

thank you

Answers

  • KD0RC
    KD0RC Member, Super Elmer Moderator

    Hi Joe, what is your TX DAX level set to?

  • joep
    joep Member ✭✭

    Hi Len....it is set to 50 which is the same setting used on HF bands that gives 100w


    73 joe

  • joep
    joep Member ✭✭


  • KD0RC
    KD0RC Member, Super Elmer Moderator

    Have you tried transmitting into a dummy load? If that gives the same results, then you should probably submit a help desk ticket.

  • J.C. W4QK
    J.C. W4QK Member ✭✭

    You may need to adjust the Audio Transmit Level slider in WSJT-X. I have mine at around 80% for 100W out on 6 meters with my 6400M. Good luck and I hope you find the cause of the issue.

  • Mike-VA3MW
    Mike-VA3MW Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    As a test:

    Set your Tune on the Radio to 100%

    Press Tune and while txing into a dummy load, read the power on your watt meter. If greater than 90 watts, all is ok with the radio and check your audio drive levels. If less, open a support ticket.

    BTW, on audio drive, never exceed -5db on the level meter.


    image.png


Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories