Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.2.20 | SmartSDR v4.2.20 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Connecting 6400M to my SPE 1.3K-FA

Options
Mark Griffin
Mark Griffin Member ✭✭✭
edited September 2021 in Peripherals & Station Integration

Good Evening,

I have just connected my 6400M to my SPE 1.3K-FA. I purchased one of Dan's cables. I have instructions from Dan on setting the power. But what about setting the CAT so my amplifier can communicate with the Flexradio. Right now the CAT is Kenwood. Any help would be very much appreciated.

Mark Griffin, KB3Z

Comments

  • Mark Griffin
    Mark Griffin Member ✭✭✭
    Options

    I pushed the Set button and went to CAT and it is now set to Flexradio. It is asking me for a baud rate. Currently the sSelection is 9600. But not sure it that is right or not.

    Mark

  • Mark Griffin
    Mark Griffin Member ✭✭✭
    Options

    Well, when I go to change the band, the band is changing on the SPE. So 9600 Baud must be OK.

  • Mark Griffin
    Mark Griffin Member ✭✭✭
    Options

    Ok guys, I am trying to follow Dan's suggestions. But when I use my paddle I see 30 watts. But evidently it is not communicating with the amplifier, because I only get 30 watts output. What am I doing wrong?

  • Mark Griffin
    Mark Griffin Member ✭✭✭
    Options

    I think I got it guys. I hit the menu and then TX band settings. I checked the RCA TX1 and my input is 15 watts and I am getting about 1175 watts output.

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories