Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

ANT selection in Memories

Member, Super Elmer Moderator

I never noticed this before, but now that I have a transverter, it is a minor pain to deal with.

If I am on HF and have ANT 1 selected, then click on a memory to go to a 2M FM repeater frequency, all parameters change appropriately except for the ANT selection. In this case the receive antenna stays on ANT 1 and transmit antenna is blank. OK, so I can change RX and TX to XVTA and all is well. Then when I use a memory selection to go back to an HF net frequency, the antennas stay on XVTA and I have to change back to ANT 1 on TX and RX.

I would like the ability to have RX and TX antenna selection as settable memory parameters.

Thanks for your consideration of this feature.

Tagged:
3 votes

Open for Comments · Last Updated

Leave a Comment