Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.2.20 | SmartSDR v4.2.20 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

fast switch between FT8/digital and USB voice

Options
N7CMP
N7CMP Member ✭
in SmartSDR for Mac
Most of the time I am using FT8 or JS8CALL or similar digital modes where neither my microphone, nor my headphone / speaker set up makes any difference. However, the DAX and CAT and PTT setup makes a huge difference for connected applications such as WSJT-X.

Once or twice a week, I need to switch over to single-side-band phone conversation through my Koss headphones and Flex mike plugged directly into the transceiver.

It takes me FOREVER to do that, even though I use the "MEM" function of the 6400 to store some of the info.

This evening, for example, I started out hearing the QSO, on 10 meters, but too garbled to be intelligible.

Messing with the AGC. NB. etc. I managed to get reasonable copy; when Pushed the PTT button on the mike, I got huge feedback noise that was (I assume) xmitted with my CQ.

My question is: has someone sussed out the optimal settings for (at least) these two modes? And if so, please send me a listing of the configs.

Missing out on a lot...
=CMP

Categories