Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?

SmartSDR v3.9.19 and the SmartSDR v3.9.19 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

SmartCat COM port configuration to 'auto-follow' TX slice

Options
Member ✭✭
edited May 2017 in New Ideas
It would be very useful if a a com port can be setup to follow the TX slice. This would allow third party software to connect to a single port and allow the operator to pounce on signals on different slices. 

For example if I'm working 20m on slice A but see a signal popup on 12m on Slice D, I can switch to it and immediately begin QSOing. Third party software such as logging programs connected to the COM port following the TX slice would correctly log the QSO without additional effort from the operator 




0
Up Down
0 votes

Open for Comments · Last Updated

Comments

  • Administrator, FlexRadio Employee admin
    edited May 2017
    This enhancement is already in our database as feature request #4202

Leave a Comment

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register
New Idea

Quick Links

Categories