Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v3.9.19 and the SmartSDR v3.9.19 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v3.9.19 and the SmartSDR v3.9.19 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
SmartSDR Discovery Packet requirements
Mark WS7M
Member ✭✭
Hi all,
I'm working on a fun little bridge project where I have a piece of software that is relaying packets from the Flex radio over a different interface and network.
I understand the Vita packets for the most part but I would like to understand what exactly SmartSDR is looking for in the vita packets to consider one valid.
As one very first stab I tried copying an incoming discovery packet and making changes to the payload data and re-broadcasting it. This did work and I think the reason is that SmartSDR must be looking at packet counts or other data to determine if the packet is valid.
I of course can construct my own packet but it would be helpful to know what data SmartSDR is concerned with on the UDP packets.
Thanks in advance
Mark - WS7M
I'm working on a fun little bridge project where I have a piece of software that is relaying packets from the Flex radio over a different interface and network.
I understand the Vita packets for the most part but I would like to understand what exactly SmartSDR is looking for in the vita packets to consider one valid.
As one very first stab I tried copying an incoming discovery packet and making changes to the payload data and re-broadcasting it. This did work and I think the reason is that SmartSDR must be looking at packet counts or other data to determine if the packet is valid.
I of course can construct my own packet but it would be helpful to know what data SmartSDR is concerned with on the UDP packets.
Thanks in advance
Mark - WS7M
0
Answers
-
I believe what you're looking for can be found in the wiki here.0
Leave a Comment
Categories
- All Categories
- 349 Community Topics
- 2.1K New Ideas
- 615 The Flea Market
- 8K Software
- 2 SmartSDR+
- 6.3K SmartSDR for Windows
- 173 SmartSDR for Maestro and M models
- 412 SmartSDR for Mac
- 267 SmartSDR for iOS
- 249 SmartSDR CAT
- 186 DAX
- 375 SmartSDR API
- 9.2K Radios and Accessories
- 22 Aurora
- 207 FLEX-8000 Signature Series
- 7.1K FLEX-6000 Signature Series
- 921 Maestro
- 53 FlexControl
- 860 FLEX Series (Legacy) Radios
- 894 Genius Products
- 455 Power Genius XL Amplifier
- 323 Tuner Genius XL
- 116 Antenna Genius
- 283 Shack Infrastructure
- 199 Networking
- 444 Remote Operation (SmartLink)
- 138 Contesting
- 754 Peripherals & Station Integration
- 139 Amateur Radio Interests
- 973 Third-Party Software