Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

SmartSDR v3.8.19 and the SmartSDR v3.8.19 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

6300 AGC on 50MHz

Ian GM4KLN
Ian GM4KLN Member
edited December 2019 in SmartSDR for Windows
I have been using my 6300 a lot recently on 50MHz digital modes - especially JT6m and JTMSK, but also CW, and run successfully with my AGC turned off. However, I have noticed that whilst AGC appears to be off, the actual audio (using "remote") to my speakers seems to maintain an AGC profile (i.e. audio vanishes then slowly recovers) whilst the signal seen on the waterfall, etc. is - as expected - virtually flat response following a spike etc.   This all on SSDR 1.6.21. and using MSHV v1.15 and WSJT 10 r6088 or WSJT-X v1.6.1 r5910. 
Its not an issue for JT modes, but its not ideal for CW, as I can't hear the incoming signal until the AGC recovers. 
Anyone else notice this - or - am I not understanding what AGC Off implements / affects? 
73, Ian GM4KLN 

Answers

  • Ian GM4KLN
    Ian GM4KLN Member
    edited December 2019
    <<bump>>  

    No-one else seeing this?   
    RX is working fine - JT65A is seeing things on EME so can't complain about that!...

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories