Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Temporary cw keyer issue

Options
Member ✭✭
edited December 2016 in FLEX-6000 Signature Series
Hello,

today my 6300 keyer had a bad behavior: left paddle sent continuous tone after some points (about ten) while right paddle sent lines after a long delay (about two continuous lines). It was totally out of sync with my code.
At the beginning I thoughts it was due to a bad setup of my new Begali Leonessa but with the Elad Duo it worked well.
After having restarted more times rig and computer I had to downgrade to version 1.5.0 and then reload the 1.5.1 firmware to solve this problem.
I am wondering if this behavior can hide other problems and if someone else had the same experience.
I am a bit confused now.

73' Enzo
iw7dmh

Leave a Comment