Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.2.20 | SmartSDR v4.2.20 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Diversity Mode Antenna RX B not being stored

Options
ka7gzr
ka7gzr Member ✭✭
edited March 2017 in SmartSDR for Windows

This is a Flex 6700 with v1.43.

I have two Pixel RF PRO-1B loop antennas phased 90 degrees from each other. They are separated by about 75 feet. One goes to port "RX A" and the other to port "RX B" in Diversity mode. This makes a nice "Diversity" set up. 

I store these in a profile but I experience a problem. Rx A stores fine in slice A but slice B will not store Rx B. It always stores ANT1. Is this "normal"?

Jim

ka7gzr

Comments

  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited March 2017
    Options
    This looks to be a defect.  I have written this up in our bug tracker for further investigation.  Thanks for the report.
  • ka7gzr
    ka7gzr Member ✭✭
    edited March 2017
    Options

    Tim,

    This appears not have been fixed. In addition to the above issue, when in the diversity mode the volume balance level and audio on/off is not retained properly. Was this to be fixed with v1.6? 

    Thanks,

    Jim


  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited December 2016
    Options
    This is defect #1921 and it was not addressed in the current release of SmartSDR.

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories