Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.1.5 | SmartSDR v4.1.5 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

PTT does not release power

Bob G W1GLV
Bob G W1GLV Member ✭✭
edited June 2020 in FLEX-6000 Signature Series
On several occasions today, the output power would not release with PTT released. I tried restarting SSDR V1.2 still the same. Shutdown the radio and disconnected the 13.8 volts. Restarted the radio with the OK button depressed, still the same results. I had to shutdown the radio to release the PA. Not good for remote operation.

Comments

  • K2CM
    K2CM Member ✭✭
    edited June 2020
    I have had this too. Traced it to RF feedback.....rf was getting into everything. Try it with one watt out, if it goes away, it's rf feedback. Fixed it by making a better ground and putting rf cores on all cables attached to my F6.7K.
  • Bob G W1GLV
    Bob G W1GLV Member ✭✭
    edited December 2016
    Thanks for the info.

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories