Can't Switch to 20M or 10M

Jerry Gardner

Last night I had two panadapters open, both on 15M. The one at the top of the screen had one slice receiver open and was tuned to 21.076 and was supplying audio via DAX channel 1 to wsjt-x. The one on the bottom of the screen had one slice receiver tuned to 21.300 in USB mode.

When I tried to switch the bottom panadapter to 20M or 10M, nothing happened. The 20M and 10M buttons appeared to depress, but the band didn't change. I could, however, switch this panadapter to 12M or 17M. I didn't try typing a frequency directly into the slice, however.

I had to delete the panadapter and recreate it before it would let me switch to 20M or 10M.

This is intermittently reproducible. It happens about half the time. 

Tim - W4TME

This sounds like an orphaned slice resource issue.  We made some improvements in the upcoming SmartSDR v1.2 that may fix this behavior.