Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Best Of

  • Re: Using ZeroTier one

    I wrote this 'wedge' the other day and I was given permission to share it. I use it from time to time for testing over a VPN when I need to eliminate SmartLink. This will allow you to see y…
  • Re: VPN discussion on which type

    Name of VPN (SoftEther, WireGuard, OpenVPN, TailScale, ZeroTier, Ubiquity, etc) ZeroTier Server (radio end) requirements (RPI, runs on a Router, etc) Runs on Most Routers or a Pi Client requires (run…
  • Re: VPN discussion on which type

    From John G4IRN: Name of VPN - ZeroTier Server (radio end) requirements - RPI running LAN <> ZeroTier bridge. Client requires - ZT client software runs on PC. I also have ZT running on my home …
  • Re: VPN discussion on which type

    ZeroTier Runs on a Mikrotik Router ZeroTier Client required or a network setup with bridging over ZeroTier implemented Solves CGNAT and even runs pure IPv6 connections Low Latency, almost the same as…
  • Re: 6600 Ordered!! Need some advise!

    Do not try to do it all at once or you'll just frustrated. Get to know the radio first, how to adjust AGC-T, get on the air on SSB and then Digital. This playlist on YouTube is a must watch.
  • Re: VPN discussion on which type

    Name of VPN (SoftEther, WireGuard, OpenVPN, TailScale, ZeroTier, Ubiquity, etc): SoftEther Server (radio end) requirements (RPI, runs on a Router, etc): PC and RaspPI Client requires (runs on PC, MAC…
  • Re: API Xmit command with MultiFlex

    Yep, the API documentation is a bit out of date for a few commands, but most of it is accurate. I do the bind in the GUIClientUpdated routine: radio.GUIClientUpdated += new Radio.GUIClientUpdatedEven…
  • Re: VPN discussion on which type

    Danny and Ron, your comments got quarantined by the spam filter. I released your comments when I discovered them in the spam queue this morning. Going forward, you should not have this issue.
  • Re: VPN discussion on which type

    Mike - An additional item that might be helpful in your survey. Have you tested the implementation on SmartSDR (Windows 10, Windows11)? Have you tested the implementation on SmartSDR (Mac/iOS/iPadOS)…
  • Re: N1MM / MMTTY and SmartSDR setup video

    As a new MMtty user - this was a very interesting video and only just installed N1mm program so the other vids that are comming will be of interest to get this up and running properly for a new user …