Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Erik SM0JCA ✭✭

  • Re: Chasing RFI

    Hello all again, back after some chores, hi :)Thank you all for good comments and advice.I have read up on most of the available papers on common mode currents,grounding, lightning protection and wha…
  • Re: ANT1 and ANT2 Problem

    I am also scratching my head how to configure antenna switching for SO2R. I have a 6600 and amplifier SPE Exper 1.3k-FA. 4O3A company has just come up with a number of advanced switches to help with …
  • Re: Linear amp tripping to standby at FT8 using Flex Radio 6400M

    I was a bit premature when stated that the problem was solved. I had to clean up the drivers on the computer and after a suggestion from Tim Ellison to change the length of the coax cable between the…
  • Re: V3 and Slicemaster 6000

    I just upgraded my 6400M and SmartSDR to v 3 and it seems to be OK. Also found out that SliceMaster is not working but WSJT-X in FT8 mode works fine when I set the radio CAT port to Kenwood TS-2000, …
  • Re: Chasing RFI

    There are several building projects for RF current measurement instruments online but the best one I have found is this one:https://owenduffy.net/module/icm/index.htm73 de Erik