Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: How to connect the FHM3 via the Y cablew to the Maestro C
Sorry, forgot to mention that the Y cable male plugs into the Maestro C HDST input. Bob, KN4HH1 -
Re: How to connect the FHM3 via the Y cablew to the Maestro C
Here is the connection that works. FHM3 3.5mm plugs into the Y cable marked Mic. Make no connection to the other Y cable connector. Use RCA to 3.5mm adapter on FHM3 RCA plug. Plug the adapter into th…1 -
Re: How to connect the FHM3 via the Y cablew to the Maestro C
No, when you put a mic only into the Y cable and connect it to HDST, RX audio is not muted. Bob, KN4HH1 -
Re: V3.3.29 update unsuccessful on Flex 6500
Additional information. I shut down the radio and re powered radio and now it will not complete the calibration cycle.1 -
Re: Smartlink test fails revisited
Thanks Mike and Ed. I needed the networking 101 you provided, Mike. I had two settings to adjust. I did not properly assign the forwarded ports. I had UDP and TCP ports reversed. Also, I had to assig…1