Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
StarLink Commercial, My Experience
There has been a lot of discussion about using StarLink Internet with Flex SmartLink. SmartLink was not usable because of the double NAT and Carrier Grade IP address. Until, StartLink introduced Star…2 -
8X4 Super Switch With Node-Red Interlocks
I added a second Flex 6600 and a second 8X2 Antenna Genius, OM Module, and 8XAB Switch to enable sharing all antennas between 6600 Radios. One problem was the two Antenna Genius switches did not comm…1 -
Re: Stream Deck: programming buttons to reflect active slice status
Rick I do not think Dave's WiKi includes a Windows Node-Red install. Dave, am I correct? In any event, here is a link to the node red.org instructions for a Windows install...After that, Dave's WiKI …1 -
Re: Option to Automate the AGC-T setting
I continue to work on an "Auto AGC" Node-Red-based application. I am getting excellent results with virtually no background noise in any signal/noise combinations. I am using the Flex API C…3 -
Re: FRStack's SteppIR/SDA-100 not tracking frequency
Mike You did not mention how you have the SteppIR Options set up for "Antenna Type" and for "Manual Frequency Synch". If you want to control the SDA100 frequency from FRStack, be …1