What is an appropriate TXDelay to use for a THP 1.5KFX amp

  • 1
  • Question
  • Updated 5 years ago
  • Answered
I have a THP 1.5KFX amp that I have been using with the 6300 on SSB and it works fine without any TXDelay. However, when I try CW it trips the Pr (reflected power) safety, even with fairly low drive power and a resonant antenna. I suspect that I need to put in a small TXDelay. Any suggestions short of incrementally increasing it until it doesn't trip?
Photo of Doug Seyler

Doug Seyler

  • 11 Posts
  • 0 Reply Likes

Posted 5 years ago

  • 1
Photo of Charlie

Charlie

  • 34 Posts
  • 13 Reply Likes
Official Response
I had the same problem with my 6300 and THP.  I am using 5 ms TX delay and it works fine.  No more Pr errors.