Software settings for MS-DMT MARS software with FLex 6500?

  • 1
  • Question
  • Updated 3 years ago
I use my 6500 for MARS operation.  I have it running happily with HRD/DM780 but cannot find the settings in the MS-DMT setup to make it key the 6500.
Photo of N1UW

N1UW

  • 34 Posts
  • 9 Reply Likes

Posted 3 years ago

  • 1
Photo of K6OZY

K6OZY, Elmer

  • 524 Posts
  • 195 Reply Likes
I use DAX 2 for my MARS MS-DMT and then setup Virtual Serial Port for an interconnect between MS-DMT and MsgTerm using COM 1 / 99 pairs.

Pictures say a thousand words, so here's a snapshot of the config pages for my working setup.  You must use a PTT Port to trigger.

Photo of N1UW

N1UW

  • 34 Posts
  • 9 Reply Likes

This did the trick!  My settings are only slightly different in terms of the actual com port used but the general principle is right on. Consider the question answered.  Thank-you.

73 Frank N1UW

(Edited)
Photo of Andrew O'Brien

Andrew O'Brien

  • 379 Posts
  • 43 Reply Likes
I do the same with Flex 3000 and PowerSDR.  DDutil is involved too. 
Andy AAR2BY