Selecting 2M shuts down the 6700

  • Problem
  • Updated 2 years ago
  • Solved
Selecting the 2M band immediately disables the 6700. SSDR reports the disconnect and removes the radio from the selection list. One minute later it reappears. Repeatable.
Photo of Stan - VA7NF

Stan - VA7NF

  • 214 Posts
  • 49 Reply Likes

Posted 2 years ago

  • 1
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 3143 Posts
  • 881 Reply Likes
What version of software are you running?

Also what is your panadapter / slice configuration when this problem occurs?
Photo of Stan - VA7NF

Stan - VA7NF

  • 214 Posts
  • 49 Reply Likes
Software: SSDR 1.0.24, nothing else started

Process: Turn on 6700 and connect to SSDR (Comes up on 20M with no receivers)
+RX and get a receiver on 14.008 USB
Select BAND -> 2M and get the disconnected message

It is repeatable without selecting +RX; just BAND->2M

I believe the last operation was to use AM slope detection on FM signals (works but with horrible audio)
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 3143 Posts
  • 881 Reply Likes
Try resetting your persistence database by pressing the OK button when you power on the radio with the front panel power button.

Does it happen now?
Photo of Stan - VA7NF

Stan - VA7NF

  • 214 Posts
  • 49 Reply Likes
The power on reset corrected the problem.