RFI Finger Print and the Solution

  • 1
  • Problem
  • Updated 1 year ago
  • Solved
  • (Edited)
Attached is a Screen Dump of the RFI Signature and the Solution.
I have been searching (off and on) for over 2 years for the RFI.
The RFI was much broader than the Picture I am showing here.
It went from 14 Mhz to over 30 Mhz. An interesting part of the
signature is that each Spike had 2 small peaks and they would
switch back and forth at around 120 times per minute as best 
I could count.
I finally solved it by putting one of the 28 Mhz frequency's in my
HT and went walking around the neighborhood.
My neighbor was very helpful by switching off breakers.  It was
kinda elusive though....  It was under a bunch of stuff in the garage
and left plugged in.   The RFI was active regardless of it having a
battery in it or not.
I do not want to imply that all Hitachi battery chargers are bad.
This is just one that went dirty.

My Neighbor now has a Brand New Top of the Line Cordless Drill
and charger....   My Gift..

73's and I hope this might help someone find a similar problem

Ken  W9IE
Photo of Ken W9IE

Ken W9IE

  • 90 Posts
  • 17 Reply Likes

Posted 3 years ago

  • 1
Photo of Walt - KZ1F

Walt - KZ1F

  • 3040 Posts
  • 645 Reply Likes
That's awesome Ken! Good job!
Photo of KY6LA - Howard

KY6LA - Howard, Elmer

  • 3789 Posts
  • 1638 Reply Likes
Found the exact same issue with Ryobi Charger for their battery packs.
Photo of Allne


  • 1 Post
  • 0 Reply Likes
The fingerprint solutions can also get by some of the technique by which you can get that exact solution which you want can also get from the Hp Tech Support for more information and knowledge then try to contact with them.
Photo of Berry Smith

Berry Smith

  • 3 Posts
  • 0 Reply Likes
UIDAI desires to enhance its device technology and specifications in collaboration with the Industry partners with a special emphasis on the integrated Brother Wireless Printer Setup devices to facilitate the large-scale adoption of authentication for consumer transactions.