question about SPE with Flex radio

  • 1
  • Question
  • Updated 7 months ago
  • Answered
Hi,
maybe the answer has already been given but I'm still going.
I have a flex 6300 and a SPE Expert 1.3k I think for all flex XXX and amp SPE it's the same setting.
I learned that you should not connect the ALC of the flex because it's analog.
You have to set each band in LOW, MID and MAX power. It appears then "[PC = xxx]" in the command. The question is how do you do with the Flex and the Expert?
Thank you for the answer
73ON5AM
Photo of ON5AM

ON5AM

  • 49 Posts
  • 3 Reply Likes

Posted 7 months ago

  • 1
Photo of Ria - N2RJ

Ria - N2RJ, Elmer

  • 2270 Posts
  • 904 Reply Likes
Official Response
Once you have the CAT cable wired up, set the amplifier to FLEX mode. To set each power drive level use the arrow keys on the amp. 

You need to set it once per band and power level. 

For example, on 20 meters you have to do a separate drive setting for Low, Mid and Max. Then repeat for 40 meters. Then 80, 160, 30, 17, 15, 12, 10, 6

Dedicate some time for it. 

Once you do that, you are all set. 

Ria