Odd behavior on TUNE

  • 1
  • Problem
  • Updated 5 years ago
  • Solved
Doing my job as a "pre-release" tester....

6500 / flex control knob, Win-8, running current 0.13.10 software.

I noticed when I had two pan windows open, one on 80 meters and the other on 10 meters, and tuned just outside the high end of 80. I hit "tune," and it didn't transmit (as expected.) But when I turned the flex knob back into the band, the rig went into "tune" mode without my hitting the button.

I have repeated this several time in order to diagnose it.
If I hit "tune" once, it goes into tune mode but doesn't transmit - the receiver is still operating - and if I dial back into the band the rig goes into "tune" mode.

If I hit "tune" button twice, it toggles back into receive and does not go into "tune" when I dial back into the band.

No biggie, but could cause a problem.

Ken - NM9P
Photo of Ken - NM9P

Ken - NM9P, Elmer

  • 3970 Posts
  • 1225 Reply Likes

Posted 5 years ago

  • 1
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9148 Posts
  • 3467 Reply Likes
Official Response
This issue has been fixed in SmartSDR v0.15.x and greater