No SSB audio after switching to CW on another slice and coming back

  • 1
  • Problem
  • Updated 7 months ago
I am having an issue where I can have one slice on LSB and be talking. Fire up another slice and set it to CW (same band) and make it the active TX slice. After I send CW I cant get SSB TX audio on original slice. I have to restart radio.

If I switch the SSB slice to CW and send CW and go back to LSB it is fine.  Just cant switch to CW on another slice and come  back to the SSB slice.
Photo of Rich McCabe

Rich McCabe

  • 1105 Posts
  • 238 Reply Likes

Posted 8 months ago

  • 1
Photo of Ken - NM9P

Ken - NM9P, Elmer

  • 4166 Posts
  • 1329 Reply Likes
Which rig and what version of software are you using?
Photo of Rich McCabe

Rich McCabe

  • 1105 Posts
  • 238 Reply Likes
Hi Ken,

6600 and latest version 2.0

73
Photo of Rich McCabe

Rich McCabe

  • 1105 Posts
  • 238 Reply Likes
Photo of Rich McCabe

Rich McCabe

  • 1105 Posts
  • 238 Reply Likes
To add to this I just realized if I bump the frequency on Slice A it will transmit and I don't have to shut down.

I think I will fill out a support ticket. Seems to be a bug.
Photo of Rich McCabe

Rich McCabe

  • 1105 Posts
  • 238 Reply Likes
Flex has confirmed its a bug in software defect in SmartSDR v2.4.9 and has logged it.