1.3 Level Meter miscalibrated for DAX?

  • 6
  • Problem
  • Updated 4 years ago
  • Acknowledged
  • (Edited)
When using audio from DAX, I cannot get the set RF power until the main level meter bar (on the SmartSDR "P/CW" panel) is all the way up to zero and the peak indicator shows way into clipping.  This is new behavior to 1.3.0.

In this particular case, I am using the Tune signal from WSJT-X, which is just a sinewave (1307Hz for my current WSJT-X setting, but the problem does not seem to be dependent on frequency ).

The frequency is 50.276MHz and RF power is set to 50W and I need to bring the level up as shown to get 50W:


If I set the level as recommended (manual section 25.3.3) I get 17W:
Photo of Bob Wright, N7ZO

Bob Wright, N7ZO

  • 268 Posts
  • 66 Reply Likes

Posted 4 years ago

  • 6
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9148 Posts
  • 3467 Reply Likes
Official Response
There is something going on with the transmit levels.  We have a defect listed for it and are actively investigating it.
(Edited)