For FT-8 TX Settings

  • 1
  • Question
  • Updated 1 year ago
  • Answered
I have the 6500 and would like to know if there are preferred TX equalizer settings for FT-8? Should it even be turned on?
Photo of W9ILY

W9ILY

  • 68 Posts
  • 6 Reply Likes

Posted 1 year ago

  • 1
Photo of Jim Gilliam

Jim Gilliam

  • 932 Posts
  • 218 Reply Likes

That's a good question. I have wondered if the TX equalizer is bypassed when using the DAX.


Photo of Ken - NM9P

Ken - NM9P, Elmer

  • 4236 Posts
  • 1351 Reply Likes
Dax in and of itself -- NO.  But when using DigU/DigL the EQ and Processor are turned off.  but watch the audio input levels.  Digital sigs don't like overdrive...
Photo of Ken - NM9P

Ken - NM9P

  • 4239 Posts
  • 1351 Reply Likes
Official Response
Always run FT8, and all other digital modes except RTTY in DigU, which turns TX EQ, Compression, etc OFF.  (Run RTTY in RTTY Mode, unless you are using FLDigi)

You DO need to make sure that the Mic Profile you use for DigU has the transmit filter set wide enough (Usually 3K on FT8) that your total audio spectrum will pass as you move within the FT8 passband.

Then you also need to watch the Audio level so that you are at least a few dB below the Red Line to avoid distortion caused by overdrive.

Ken - NM9P
Photo of Bob Gerzoff, WK2Y

Bob Gerzoff, WK2Y

  • 197 Posts
  • 17 Reply Likes
No equalizer. Flat across.  No compression either.  I know you can still highlight the buttons and it seems to me that the equalizer is not by passed using DAX, but I can not confirm.  
73,
Bob, WK2Y
Photo of Ken - NM9P

Ken - NM9P

  • 4239 Posts
  • 1351 Reply Likes
Always use DigU. Then you can have a Mic Profile for the digi modes that doesn’t conflict with your SSB Mic Profile. And you won’t accidentally leave EQ set or PROC on.

Why do anything else?
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9186 Posts
  • 3548 Reply Likes
Always use DIGx for digital modes.  For FT-8, use DIGU
Photo of W9ILY

W9ILY

  • 68 Posts
  • 6 Reply Likes
Thanks for all the responses. It sure clears up things.
Photo of Dave - WB5NHL

Dave - WB5NHL

  • 285 Posts
  • 64 Reply Likes
Also watch your TX power setting.  FT-8 is a 50% duty cycle. The FLEX PA temperature can build up pretty quickly.  Use K9DUR SDRMonitor utility or FRStack to watch the temps.
Photo of rjguidrysr

rjguidrysr

  • 98 Posts
  • 14 Reply Likes
TX filter got me last night. OPEN up Wide if going over 3khz