Flex 6600m and N1MM SO2R not working properly

  • 1
  • Problem
  • Updated 4 months ago
  • (Edited)
Hello
Setting up SO2R on Flex 6600M. RX working fine and correct switch between radio1 and radio1, but TX not. Sometimes when I start CQ on radio2, radio still TX on radio1. I have to repeat few time F1-ESC to start TX on correct radio.
take a look short video
https://youtu.be/v2ULwOIxugo

P.S. Writelog working correctly.

Yuri
Photo of N2TTA

N2TTA

  • 31 Posts
  • 3 Reply Likes

Posted 4 months ago

  • 1
Photo of Chris Tate  - N6WM

Chris Tate - N6WM, Elmer

  • 808 Posts
  • 217 Reply Likes
What is that error that keeps popping up on your Maestro?
Photo of N2TTA

N2TTA

  • 31 Posts
  • 3 Reply Likes
Photo of N2TTA

N2TTA

  • 31 Posts
  • 3 Reply Likes
No, run PC at radio site is not the options for me, i like few monitors, ext...
I’m operated remote from 2011 with remoterig as NP2P.
will see, if big speed will not fixed the problem i wii comeback to remoterig with K3.

Yuri
(Edited)
Photo of Chris Tate  - N6WM

Chris Tate - N6WM, Elmer

  • 808 Posts
  • 217 Reply Likes
Yes I have been down that road, the whole reason for transition from K3 to Flex for me was the persuit of a remote pan adapter.  I have been working many years to find the sweetspot.  There are definitely more latency and bandwidth issues with the flex, but everything is a tradeoff.  there is more data passing with the flex environment, most importantly that all important band scope.  You definitely need to weigh your options. 
(Edited)
Photo of N2TTA

N2TTA

  • 31 Posts
  • 3 Reply Likes
I hope I find a solution how to fix this problem
Photo of Chris Tate  - N6WM

Chris Tate - N6WM, Elmer

  • 808 Posts
  • 217 Reply Likes
Me too!  , NP2P is in my contest logs NUMEROUS times.. thanks for all the qso's. I wish you the best of luck and feel free to reach out if I can help.
Photo of N2TTA

N2TTA

  • 31 Posts
  • 3 Reply Likes
Thank you, CU in IARU tomorrow
Photo of N2TTA

N2TTA

  • 31 Posts
  • 3 Reply Likes
Updated speed to 20up/6down at radio side, but actually I have 9up/3down. Will call them tomorrow and make complaints

Latency now 120-170ms and problem not resolved ((

Even if I set max delay time for CW, have same problem. Maybe it’s not a speed factor?

Looks like I have to start learning how to operate in WL
(Edited)
Photo of N2TTA

N2TTA

  • 31 Posts
  • 3 Reply Likes
I have this message now
Photo of Tim K9WX

Tim K9WX

  • 36 Posts
  • 5 Reply Likes
Yuri, can you share a bit more info on your setup?  Specifically, are you using PTT ports with N1MM?  Also, do you have one or two Winkey ports for your set up (one that serves both slices or one per slice)?
Tim K9WX
Photo of N2TTA

N2TTA

  • 31 Posts
  • 3 Reply Likes
Tim,
i use one remoteig for CW, for both slices. no PTT check at N1MM