CAT 1.6.17 interface when operating split not reporting VFO B?

With the FLEX-6000 there is no such thing as "split within the same slice" since to operate split it requires a Slice A and Slice B.

In order to use a single CAT port assigned to any slice to operate split, meaning that the port will issue and respond to commands intended for both VFO A and VFO B, the third-party application has to send a split enable command to the radio via CAT to put it in split mode.  This would be ZZSW1;  or the Kenwood command FT1;  When you issue either of these commands, it will create the split slice to emulate VFO B which is a clone of the slice associated with the CAT port that is emulating VFO A.

This is a consequence of expanding CAT so it is no longer restricted to Slice A and B.  As such, you can actually operate split on 4 different bands (4 slice pairs) using a FLEX-6700.

ZZSW0;