Boot problems with 6600M

  • 1
  • Problem
  • Updated 2 years ago
After booting straight to the opening screen for some time since the last firmware update, my 6600M has now reverted to stopping at the screen that requires you to enter the firmware version and then to manually choose, run etc.Not only that when it reaches the opening screen, all that shows is part of the top section with the Menu. There is nothing else displayed. If I shut down with the power button and then switch it back on again, it then boots normally - or at least it did this time.I do not know if this is a bug in the firmware or if the recent behavior is the result of a Window 10 update.Either way, it is not very good. Perhaps Flex are aware of this altered behavior and it will be corrected in the next firmware update ?
Barry SimpsonĀ  VK2BJ
Photo of Barry Simpson

Barry Simpson

  • 24 Posts
  • 2 Reply Likes

Posted 2 years ago

  • 1

Be the first to post a reply!