Antenna setting forgotten, sometimes DAX too

  • 1
  • Question
  • Updated 3 years ago
  • (Edited)
I have started using ant 2 for the first time in a while under 1.5.1. It is only for 30 meters. What happens is, if I type in the frequency, it does not always cleanly set the rec and xmit antennas to 2 when I move from another band to 30 and back again to 1 when I again type a frequency that switches bands. But two was the last setting for 30 and it is 1 everywhere else. It also sometimes "unsets" the DAX assignment on that slice as well. I never change DAX assignments.

I think it works a bit better when I use the band setting logic, but I usually just type in the freq anyway.
Photo of Larry Loen  WO7R

Larry Loen WO7R

  • 205 Posts
  • 23 Reply Likes
  • irritated

Posted 3 years ago

  • 1

Be the first to post a reply!