AG and OM module setup

  • 1
  • Question
  • Updated 11 months ago
  • 1
I received OM module today and trying to make it work. So far no lack.
Does anyone use it and could provide any help?
I use AG manual for setup and i see few things:
1. All LED's breifly blink during power up
2. I cannot see any output by either measurements or by LED.
3. Application setup for OM module looks different than in manual.
See below, I cannot get a Ouput Configuration winow to popup Outputs, it is empty.
Is there any way to diagnose an OM module if it is not dead?
Thanks
Sergey, KN7K
Will post the same quetion on 4o3a forum.

Photo of Sergey Abrikosov

Sergey Abrikosov

  • 284 Posts
  • 39 Reply Likes

Posted 11 months ago

  • 1
11 months ago
Photo of Sergey Abrikosov

Sergey Abrikosov

  • 284 Posts
  • 39 Reply Likes
Well, I am asking question and will provide a solution:)

The issue is related to 4k Monitor and Windows scaling.
The screen with Output configuration is not visible with "normal" screen scaled to 150%.
Tofix it, I had to "Right click" to AG screenshot ->choose "Compatability" -> Enable "High DPI scaling override -> System.
Now, with that settings I can manipulate Outputs, however all AG screen looks blurry.
I think when I finish settings, I will turn Off that Compatability and will have a sharp screen of AG.
Sorry for trafic.
If another issue popup, I will come back :)
Sergey, KN7K
  • 1

Powered by Get Satisfaction