Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?


SmartSDR v4.0.1 and the SmartSDR v4.0.1 Release Notes

SmartSDR v3.10.15 and the SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Number of users

charlesjacobsen
charlesjacobsen Member ✭✭
in FLEX-8000 Signature Series

I have a 8600 and a Maestro. As I am still learning how to use this radio, I gave the Maestro to another amateur so that we could both gain experience. This worked well until recently. The 8600 is in my shack upstairs. I use Windows 11 on the computer in my study downstairs to run SmartSDR. We were both able to operate at the same time. We are both using V4.01.

Something has changed now as when I use SmartSDR it cuts off the Maestro. I don't think it did this initially.

Am I just imagining the past or can I set it up so that we can both operate at the same timer?

Charles

Answers

  • David Decoons, wo2x
    David Decoons, wo2x Member, Super Elmer Moderator

    is it an 8600M? Do you have SmartSDR running on your PC in shack?

    You can have a maximum of two clients connected at a time to the radio.

    There is also a toggle setting to disable MulrtiFlex. Make sure MultiFlrx is enabled.

    73 Dave wo2x

  • charlesjacobsen
    charlesjacobsen Member ✭✭

    Dave,

    Many thanks. I think what must have been happening was that I started leaving the 8600M on all the time so that Sam could use the Maestro from his QTH. If I went into the shack, I would use SmartSDR on my PC. I see now that this is the limit of two clients if Sam is operating. I might then go downstairs and use SmartSDR on the computer in the study. This means there is a third client and Sam gets cut off on the Maestro. The answer, therefore is to make sure that I only have one case of SmartSDR running at any time.

    Thanks again,

    Charles

    MM0XFZ

  • KD0RC
    KD0RC Member, Super Elmer Moderator

    Hi Charles, the other possibility is to logically disconnect the front panel. If you put the front panel into SmartControl mode, you will then have two client logins available. Check out section 9 of the Maestro User Guide for instructions.

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories