Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.1.5 | SmartSDR v4.1.5 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

FreeDV 2.0 RADE V1 on SmartSDR for Mac

Ron K2RAS
Ron K2RAS Member ✭✭
in SmartSDR for Mac

I have FreeDV 2.0 running on my Mac using a simple Logitech USB mic but the transmitted audio is too hot and has an echo. I would like to use my studio mic connected to the front of my Flex 6500 but don't know how to configure the studio mic to drive FreeDV. The configuration is SmartSDR for Mac 2.9.71, Loopback 2.4.6 with two pass-thru loops, and MacOS Sequoia. Any direction would be appreciated on how to setup the mic. I have attached screenshots of the FreeDV audio setup.

Screenshot 2025-07-15 at 1.47.13 PM.png
Screenshot 2025-07-15 at 1.47.45 PM.png

Thanks, Ron K2RAS

Tagged:

Comments

  • Ron K2RAS
    Ron K2RAS Member ✭✭
  • K3CDY
    K3CDY Member ✭✭✭

    Hi Ron -

    Thanks for posing the question. I’d given up on FreeDV prior to this release with RADE, especially since the “waveform” capability has never really materialized for Flex gear. You’ve resurrected my interest!

    I don’t have an answer for your specific configuration, but I’m wondering if you’ve seen the YouTube presentation by K6AQ concerning this latest version of FreeDV. The speaker touches on audio setup and levels briefly starting around 22 minutes. The link is here:

    https://youtu.be/9mVCypqcBhA?si=fKtHp-pMJDqLmjxM

    Hope you get it sorted out, and I’ll look for you on the air.

Categories