Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.2.20 | SmartSDR v4.2.20 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Blinking red light on start up - brand new 8400

Options
Richardm57
Richardm57 Member, Unconfirmed ✭
edited March 2025 in FLEX-8000 Signature Series
I received my 8400 last week after waiting since July. Now upon start up the flashing green turns to flashing red before it shuts down. I gather from the technical reports this is a fan issue. Very disappointing after waiting all this time. Anyone else have this problem?

Comments

  • VE7ATJ_Don
    VE7ATJ_Don Member ✭✭✭✭
    Options

    best bet is to set up a Help Desk Ticket. The Flex techs can help diagnose what it going on.

  • Rich M5RIC
    Rich M5RIC Member ✭✭✭
    Options

    Depends how many times it flashes

    Error Conditions Certain hardware and software error conditions cause the radio to stop operating and display an error code by flashing the Power button light as follows:

    • One red flash: Fan malfunction

    • Two red flashes: Software crash

    • Three red flashes: Boot failure

    • Four red flashes: Input power over voltage

    • Five red flashes: CPU overcurrent

    • Six red flashes: Input power under voltage

    Either way, open a helpdesk ticket with Flex.

This discussion has been closed.

Categories