Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.5 | SmartSDR v4.1.5 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

N3FJP log/cluster

Bob - WD8KND
Bob - WD8KND Member ✭✭
in Third-Party Software

I encountered an issue when I clicked on the spot in my N3FJP dx cluster. It immediately sent me to the correct frequency and mode, which was 10 meters CW. Well, I noticed that my amplifier wasn't keying up. I was on 10-meter SSB when I switched over, and it was keying up there. I started to investigate and found out this.

When you switch over from the log, it doesn't set your filters and such, which I already knew. What I didn't know was that it also doesn't set the TX band settings. Has anyone else run into this and have a fix for it?

Thanks and 73,

Bob

WD8KND

Comments

  • KD0RC
    KD0RC Member, Super Elmer Moderator

    Hi Bob, yes. When I want to go to a spotted station, I use my profile for that band and mode and then click the spot in ACLog. I have been doing it that way for so long that it is just a habit that I engage automatically.

  • Bob - WD8KND
    Bob - WD8KND Member ✭✭

    Well, that's one way to do it, although an extra step. But, better than nothing. I sent an email to Scott (N3FJP) to see what he has to say.

    Thanks for the idea.

    73,

    Bob, WD8KND

  • KD0RC
    KD0RC Member, Super Elmer Moderator

    Hi Bob, I think that the issue is that N3FJP sends the frequency to the Flex without sending a band change first.

  • Bob - WD8KND
    Bob - WD8KND Member ✭✭

    I received an email from Scott, N3FJP, who said that when you come over from a spot, whatever you change will stay that way for the next time you do it.

    73,
    Bob, WD8KND

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories