Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

SmartSDR v3.8.23 and the SmartSDR v3.8.23 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
Power Genius XL Utility v3.8.9 and the Power Genius XL Release Notes v3.8.9
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Max source/sink current for USB BIT/BCD cable outputs?

Member ✭✭
in Peripherals & Station Integration
New 6600 owner here. I'm going to use USB BCD cables to drive my bandpass filters and such. The band decoders have opto isolators, which ran on 5V previously. I can change the current limit resistors on the boards, but the USB Cable document does not (unless I missed it) specify what the maximum source/sink currents are for each output as well as maximum total source/sink current. Anyone know what the specs are?
Tagged:

Best Answers

  • Member ✭✭✭✭
    Answer ✓

    K6MR

    I have attached a pdf of the FTDI specification.

    There are two part numbers for the 3.3v and the 5v versions of the FTDI chip.

    Alan. WA9WUD

    Screen Shot 2022-09-14 at 8.10.25 PM.png
    FTDI Cable.pdf


  • Member ✭✭
    Answer ✓
    Thanks much. I didn't know this was a standard FTDI product. Just what was needed.

Leave a Comment

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Quick Links

Categories