Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

wierd display after upgrading to 3.3.32

After upgrading to 3.3.32 I notice that on the PGXL display on SmartSDR there is always something displayed for SWR. (see attached) even though I am not transmitting. It remains even if I shut down the PGXL utility. Obviously if I turn off PGXL and the display goes away. Restarting PGXL and it comes back. 

I did do a cold boot following the procedures with the same results.

I submitted a help ticket.

Thoughts/suggestions

Ken

AG2K

Comments

Leave a Comment