Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.2.18 | SmartSDR v4.2.18 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Flex 6700-unable to send WSPR beacons on 60m band

Mr Radio
Mr Radio Member ✭✭✭
in FLEX-6000 Signature Series

I attempted to send WSPR beacons on 5.287200 MHz using JTDX software. MOX and TX buttons are greyed out TX bandwidth is below 3000 Hz. I can operate on FT8 and FT4 on assigned frequencies normally. Any possible solutions to this problem?

Tom, SP7WT

Answers

  • David Decoons, wo2x
    David Decoons, wo2x Member, Super Elmer Moderator

    that frequency does not look correct.

    Dave wo2x

  • Mr Radio
    Mr Radio Member ✭✭✭

    Thanks for your comment, OM David.

    Radio goes to that frequency once I select WSPR in JTDX- perhaps inaccuracy of JTDX.

    I will check WSPR frequency listed in WSJT-X.

    Tnx, Tom, SP7WT

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories