Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

SmartSDR v3.9.18 and the SmartSDR v3.9.18 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
Power Genius XL Utility v3.8.9 and the Power Genius XL Release Notes v3.8.9
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

FLEx 6300 RX signal attenuation

Member ✭
in FLEX-6000 Signature Series
During transmission I touched and moved the VFO Dial and after that the receiver is almost dead. TX is working fine and I can only hear the strong stations. No different on ANT1or ANT2. VFO A or B, the same. Power OK and SWR OK. Have reset several times, no different

Comments

  • Member ✭✭
    It might be RFI, added a few mix31 ferrite cores might help.
  • Member ✭
    I have had this contellation in about 3 years and run over 50 000 QSO and no problem...
    And the problem is not when I am transmitting, it is during receiving. The attunater shoe - 122 on all bands

Leave a Comment

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Quick Links

Categories