Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?

SmartSDR v3.10.10 and the SmartSDR v3.10.10 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

6500 Calibrating and then it says Timeout

Robert
Robert Member ✭
edited December 2019 in FLEX-6000 Signature Series
Today when I turned on the radio it got stuck in calibration mode then displayed TIMEOUT and led is blinking  red. Pulling the power then reconnecting did not help. 

Comments

  • Lee - N5LN
    Lee - N5LN Member ✭✭
    edited April 2019
    My 6500 had a similar problem two years ago.  After a 'quiet' while, it booted up normally.  However, if I then turned it off.  Turned it back on immediately, it did the same "timeout" routine.  Eventually, I returned it and there was a major failure in a component.  Mine was under warranty and I did not get a printed report of the problem.   Since then, it has worked flawlessly.   de N5LN

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories