Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.1.5 | SmartSDR v4.1.5 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Transverter LO error does not affect operational frequency

Dick Illman
Dick Illman Member ✭✭
edited March 2020 in SmartSDR for Windows
Changing LO error does not adjust tx or rx frequency. Have GPS sync for radio. 2.2.8 software. UT5JCW 146/28 transverter. Need 2250 Hz LO error adjustment.

Comments

  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited July 2018
    I have converted this topic to a support HelpDesk ticket (http://helpdesk.flexradio.com) for expedited issue resolution.  Please respond using the HelpDesk ticket for issue resolution.

    If anyone else is experiencing an issue similar to this one, please submit a HelpDesk support ticket for issue resolution.

  • Dudley WA5QPZ
    Dudley WA5QPZ Member ✭✭✭
    edited March 2020
    If your transverter has a 10 MHz reference input,  sync it to the GPS ,  then you will not need to LO error correct.  
  • Dick Illman
    Dick Illman Member ✭✭
    edited July 2018
    Cheap transverter. No 10Mhz sync.
  • George KF2T
    George KF2T Member ✭✭✭
    edited February 2019
    Can you show us your XVTR settings?
  • Dick Illman
    Dick Illman Member ✭✭
    edited July 2018
    Not sure how to show but Name=146, RF freq=146.0, LO=118.0, IF=28.0, LO=0 or -2250 (Hz)I am transmitting and receiving 2.25KHz low but changing the LO Error field changes nothing.
  • WA2SQQ
    WA2SQQ Member ✭✭
    edited July 2018
    I might be wrong, but I recall thinking the same when I set my MMT144/28 up. When I changed the offset it seemed to shift the displayed frequency, not the transverter's output. I'd make a change but did not see any change on the frequency counter sitting next to the transverter. Than I realized that after making a change to the offset, I needed to readjust the displayed frequency to the desired frequency. After a few more adjustments the displayed frequency and the actual transverter matched. Again, I might be wrong since this was 2 years ago - but it's still working OK with the latest version.
  • Dick Illman
    Dick Illman Member ✭✭
    edited July 2018
    I think that is what I discovered yesterday. I think the Smart SDR software manual could be improved but I would call this issue resolved.

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories