Another software (?) oddity - 6600M rebooted, but SSDR kept running

David Salomon · April 2018

Not sure if this should be a question or a problem. I was just operating my 6600M via SSDR, when the front panel of the radio went through a cycle exactly like when it boots. However, the SSDR software, DAXX and SmartCAT kept operating fine - not even a hiccup. When the radio was finished with its "boot" process, the front panel returned to the usual screen displayed when another user is connected.

Bob G W1GLV · April 2018

David, CAT & DAX are clients to the radio and not SSDR. In other words CAT,DAX and SSDR are connected to the radio as separate apps.

David Salomon · April 2018

I understand. My point was that the front panel of the radio itself showed a normal re-boot process. If it was actually re-booting I would have expected SSDR to stop receiving at some point during that process, then re-start. That didn't happen. SSDR was receiving continuously throughout what looked like a re-boot on the radio.

Is that clearer? Does my logic make sense?

David Salomon · April 2018

And, BTW, at the time it showed the re-boot process, I wasn't touching either the radio or the SSDR software. In fact, during part of the re-boot process, I was receiving digital traffic which decoded properly, not even a hiccup.

Another software (?) oddity - 6600M rebooted, but SSDR kept running

Welcome!

Answers

Leave a Comment

Welcome!

Quick Links

Categories