Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

SmartSDR v3.8.23 and the SmartSDR v3.8.23 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
Power Genius XL Utility v3.8.9 and the Power Genius XL Release Notes v3.8.9
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

CW Skimmer Freq. tracking

Member
edited June 2019 in FLEX-6000 Signature Series
I am using  a 6700 and the latest Smart software and have CW Skimmer working but wnem I click on a signal, the radio does not track to the new freq but stays on the original signal... what am I missing??

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Answers

  • Administrator, FlexRadio Employee admin
    edited March 2017
    You are missing SDR-Bridge (http://www.qrv.com/sdrbridge.html)
  • Member
    edited June 2019
    No... I am using SDR Bridge
  • Administrator, FlexRadio Employee admin
    edited December 2016
    Then I suspect something in SDR-Bridge isn't set up properly.  I have skimmed 4 different bands at the same time and the frequency tracks properly regardless if I click on the skimmer waterfall or the SmartSDR spectrum display.
  • Member ✭✭
    edited July 2018
    I have had some issues with SDR-Bridge and CWskimmer tracking correctly.  It rarely works the fist time I open it.  I usually have to change bands and reopen Cwskiimmer a couple of times for it to work.  The SDR-Bridge window always has the proper frequency but not CWskimmer.  I believe I am running the newest version.  Once I get it working, it works OK for the most part.  However, I had a strange issue with it this past weekend.  I couldn't get it to track on 6 meters under 50.8mhz.  It would track fine until I hit 50.8 and then it would just stop.  Never could get  it to go below 50.8.  The SDR-Bridge window would track the frequency properly but it wouldn't translate over to CWskimmer.
  • Member
    edited June 2019
    That is the same problem I have.... Except for Six meters....once I get it to run now it runs OK

Leave a Comment

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Quick Links

Categories