Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?


SmartSDR v4.0.1 and the SmartSDR v4.0.1 Release Notes

SmartSDR v3.10.15 and the SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Keyer audio

Member
edited May 2018 in FLEX-6000 Signature Series
Bencher cw paddle stopped producing sound. It was working fine for about a week but when I powered on the radio today it produced no audio. What am I doing wrong?

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Comments

  • Member ✭✭
    edited January 2018
    Sidetone button turned off perhaps, or the sidetone slider got turned down to 0.
  • Member
    edited May 2018
    Thanks. Where do I find this adjustment?
  • Member
    edited May 2018
    Ps note to documentors there is a reference in the documentation to this setting but no information where it can be found.
  • Member ✭✭
    edited January 2018
    Right below the speed setting slider and above the Breakin & Iambic buttons on the P/CW section.  If you're not seeing that, you may just have your mode set to something other than CW, in which case you'll not be able to transmit CW or hear the sidetone.

  • Member
    edited May 2018
    Rick, thank you. The side tone was set to 80. I lowered it to 70 and raised it back up and the paddle began to work

Leave a Comment

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Quick Links

Categories