Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?

SmartSDR v3.9.19 and the SmartSDR v3.9.19 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Flexradio 6500 low power output

Options
Member ✭✭
edited February 2019 in SmartSDR for Windows
Flexradio 6500
HW version 1.5.1.70
When transmitting via DAX or Microphone, the output power never gets above 20 watts.  Radio had been working normally until last night.  I was operating JT65 and all fine running at about 30 watts.  This afternoon after powering back up, output power is very low.  I checked the DAX settings and it seems fine with the transmit level below 0db.  With the RF power setting at maximum I can only output around 20 watts.  I then tried the microphone on 10 meters with the radio set at USB and the microphone set to 50 percent.  I was only able to get around 10-15 watts output on both the SmartSDR RF power meter and also a Daiwa CN0801 that I have inline.  The SWR is below 1.5:1 on my hexbeam on all bands that I tried this on.  I have performed a factory reset of the radio and reinstalled SmartSDR v1.5.1.  Still having the same issue.  Any suggestions?

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Comments

  • Member ✭✭
    edited December 2015
    Power supply is a Astron 50 at 13.8v measured with a fluke meter.  Additionally, the amperage drawn is very low, less than 10 watts on the Astron's meter.

  • Member ✭✭
    edited December 2015
    Make that less than 10 amps.
  • Member ✭✭
    edited December 2015
    It will also produce low power at tune with the tune Pwr at 100 percent.
  • Member ✭✭✭
    edited February 2019
    Is the +20db mic setting on? Do you get full carrier in CW?
  • Member ✭✭
    edited April 2017
    The +20 is on.  I have never used the CW mode.  When I select the CW mode and hit MOX there is no output.
  • Member ✭✭✭
    edited November 2016
    Might want to open a helpdesk ticket directly with FRS?


    73

    Steve
    K9ZW
  • Member ✭✭
    edited August 2016
    With one 6300 here was the same issue - low power like 25- 30watts with full output - one of transistor RD100 in power amp was damaged . If no others make sence only this thing can be.
  • Administrator, FlexRadio Employee admin
    edited March 2017
    I have converted this topic to a support HelpDesk ticket (http://helpdesk.flexradio.com) for expedited issue resolution.  If anyone else is experiencing an issue similar to this one, please submit a HelpDesk support ticket for issue resolution.
  • Member ✭✭
    edited August 2016
    This ended up being a failed final.

Leave a Comment

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Quick Links

Categories