Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?

SmartSDR v3.9.19 and the SmartSDR v3.9.19 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Software settings for MS-DMT MARS software with FLex 6500?

Member
edited November 2019 in SmartSDR for Windows
I use my 6500 for MARS operation.  I have it running happily with HRD/DM780 but cannot find the settings in the MS-DMT setup to make it key the 6500.

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Answers

  • Member ✭✭
    edited August 2017
    I use DAX 2 for my MARS MS-DMT and then setup Virtual Serial Port for an interconnect between MS-DMT and MsgTerm using COM 1 / 99 pairs.

    Pictures say a thousand words, so here's a snapshot of the config pages for my working setup.  You must use a PTT Port to trigger.

    image
  • Member ✭✭✭
    edited July 2015
    I do the same with Flex 3000 and PowerSDR.  DDutil is involved too. 
    Andy AAR2BY
  • Member
    edited December 2016

    This did the trick!  My settings are only slightly different in terms of the actual com port used but the general principle is right on. Consider the question answered.  Thank-you.

    73 Frank N1UW

  • Member ✭✭✭

    I have not used MS-DMT these days

    Andy K3UK

Leave a Comment

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Quick Links

Categories