Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v3.10.15 and the SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v3.10.15 and the SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Profile List Problem
Walt - KZ1F
Member ✭✭
The following code exists in Radio.cs @ 7502
case "tx":
if (_profileTXList.Contains(profile_name)) {
_profileTXSelection = profile_name;
RaisePropertyChanged("ProfileTXSelection");
}
else {
Debug.WriteLine("Profile List Problem!");
}
break;
What I think is weird, conscious ignorance, is this condition is only flagged for the tx profile not the global, mic, or displays.
This line is preceded by the following statuses from the radio.
received status S5B89EDCD|profile tx current=
Profile List Problem!
received status S5B89EDCD|profile mic current=
Is this something that you guys wanted to capture or track? I am seeing it for profile mic as well, as you can see.
thanks,
Walt - kz1f
case "tx":
if (_profileTXList.Contains(profile_name)) {
_profileTXSelection = profile_name;
RaisePropertyChanged("ProfileTXSelection");
}
else {
Debug.WriteLine("Profile List Problem!");
}
break;
What I think is weird, conscious ignorance, is this condition is only flagged for the tx profile not the global, mic, or displays.
This line is preceded by the following statuses from the radio.
received status S5B89EDCD|profile tx current=
Profile List Problem!
received status S5B89EDCD|profile mic current=
Is this something that you guys wanted to capture or track? I am seeing it for profile mic as well, as you can see.
thanks,
Walt - kz1f
0
Answers
-
The code mentioned was written to debug a tx profile issue. Note that Debug statements are ignored when compiling in release mode. We will often leave debug code in place for future reference when looking into a problem.0
-
Thanks Eric, I did not know that about DebugWrite. I just learned my 'something new' today, so I suppose I can go back to bed.0
Leave a Comment
Categories
- All Categories
- 354 Community Topics
- 2.1K New Ideas
- 619 The Flea Market
- 8K Software
- 3 SmartSDR+
- 6.3K SmartSDR for Windows
- 176 SmartSDR for Maestro and M models
- 414 SmartSDR for Mac
- 267 SmartSDR for iOS
- 252 SmartSDR CAT
- 188 DAX
- 377 SmartSDR API
- 9.2K Radios and Accessories
- 25 Aurora
- 220 FLEX-8000 Signature Series
- 7.1K FLEX-6000 Signature Series
- 926 Maestro
- 53 FlexControl
- 862 FLEX Series (Legacy) Radios
- 898 Genius Products
- 457 Power Genius XL Amplifier
- 325 Tuner Genius XL
- 116 Antenna Genius
- 287 Shack Infrastructure
- 202 Networking
- 445 Remote Operation (SmartLink)
- 141 Contesting
- 761 Peripherals & Station Integration
- 139 Amateur Radio Interests
- 979 Third-Party Software
