Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

SmartSDR v3.9.18 and the SmartSDR v3.9.18 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
Power Genius XL Utility v3.8.9 and the Power Genius XL Release Notes v3.8.9
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Tuning amp.. tools for the serious flex contester

Member ✭✭
edited May 2020 in New Ideas
It would be great in Smart SDR if there was a button to pass the tune power level to the actual drive power level on demand.  Say you are driving a manual amp.  you dial it all in, but then you need to manually note your tune power and adjust the drive power accordingly.  why not have a "send tune power to drive power" button?  I may have some additional observations as I attempt to get this maginificent rig into competitive shape.
0
Up Down
0 votes

In Review · Last Updated

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Comments

  • Member ✭✭
    edited May 2020
    Chris,

    Take a look at DDUtil - DDutil has the ability to control radio output power by band and by amp.  There's also a quick set button on the DDUtil main control panel that allows you to save the power level to the autosets.

    Makes band changes etc a breeze.

    Stu K6TU
  • Member ✭✭
    edited May 2020
    Chris As Stu stated Ddutil will do just what your asking. If you have one of the Amps built into the Ddutil program its operation is seamless and full remote operation is possible. Ian
  • Member ✭✭
    edited April 2017
    thanks guys ill investigate this a bit..
  • Member ✭✭
    edited November 2015
    Have seen DDutil go full output So you still must watch 

    Possible fixed on Latest revision ??

    Still a good function.

  • Member ✭✭
    edited September 2015
    U must always confirm activate monitor intervene when necessary. The latest DDutil seems very stable only error occasionally is the 50% power selection. Ian

Leave a Comment

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register
New Idea

Quick Links

Categories