Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?

SmartSDR v3.9.19 and the SmartSDR v3.9.19 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

TCP client identification syntax "C1|client program surfacecontrol"

Member ✭✭
edited February 2017 in SmartSDR API

Is there a specific syntax for specifying a client name?

I have finally found the time to get deep down and dirty and start writing something using the TCP API Protocol and was just wanting to setup my program name - but alas....I get this no matter what I set it to.

C1|client program surfacepad
V1.1.0.0
H90879C4D
R1|10000002|unknown client program
M10000001|Client connected from IP 10.0.0.199

Yet if I emulate SmartSDR

C1|client program SmartSDR-Win
V1.1.0.0
H28F27383
R1|0|
M10000001|Client connected from IP 10.0.0.199

Is this for clients that are registered in the Firmware only?  if so, I will move on!


Answers

  • Community Manager admin
    edited February 2017
    A 0x1xxxxxxx message is styled as Informational.  A 0x5xxxxxxx is an error.  So this in an informational message to let you know that the firmware has no particular knowledge of your application and will not do anything to treat it any differently ;-)

    Steve
  • Member ✭✭
    edited March 2015
    Thank you!

Leave a Comment

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Quick Links

Categories