Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

SmartSDR v3.9.18 and the SmartSDR v3.9.18 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
Power Genius XL Utility v3.8.9 and the Power Genius XL Release Notes v3.8.9
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Feedback on Sideband

Member ✭✭
edited September 2019 in SmartSDR for Windows
Feedback on sideband: Running 0.15.13 on 6700. I've only been receiving on both sideband and digital since new version came out until today. I responded to a CQ on 17 and immediately heard audio feedback. I switched to dummy load, same. I disconnected ACC cable to SignaLink USB, same. I disconnected speakers and phones, same. I changed from Heil 781 to original handheld Flex supplied mike in front jack, same. I changed computers, same. At that time I had one receiver on 20 and was transmitting on 17. I changed to transmit on 20 and have open receiver on 17, gone. I reversed, transmit again on 17 and receive on 20, gone. No problem now. I'm preparing article for the "Journal of Irreproducible Results."

Comments

  • Member ✭✭
    edited November 2018
    Now when I attempted to do an ATU the transmitter hung at full power and would not come out. I lost control -- clicking on Tune, MOX, ..... nothing worked for a while. Finally I got it off. There are other reports now of feedback on CW and several with experiences similar to mine. It appears to me this is all related. This is a showstopper and must be fixed ahead of anything else.
  • Member ✭✭
    edited September 2019
    I have provided details in another post, a few minutes ago, on what causes the transmitted signal to be hear in phones/speakers. Restarting SmartSDR is the only way that I have found to eliminate this once it occurs.
This discussion has been closed.

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Quick Links

Categories