Scrolling 'Profiles' changes freq.

W4TMW

R.E. F6300
   I have a goodly number of 'Profiles', sometimes requiring me to scroll down to find what I want. I just noticed that while scanning my 'Profiles' using the thumbwheel of my mouse, the radio's  freq. changes. As you might surmise, when I QSY to the new 'Profile', then return to the previous freq. w/o using 'Profiles', I'll be presented with a different freq. due to the prior action of the mouses' (mice:) thumbwheel.  
   Seems to me when I'm manipulating the 'Profile' dropdown list my actions should not change the radio's freq. before moving to the new 'Profile'............just an observation.
Tom W4TMW

Steve N4LQ

Hmmm. I wondered what was going on.
The TX profile thing never made any sense either. When I choose a profile, the TX profile is liable to pop up almost anything or do nothing. It's pretty useless.
I believe Flex is changing the entire memory system in one of the next releases. Let's hope so.

Tim - W4TME

I don't think that is the intended behavior when the Profile window is in focus, so I have written this up as a defect in our bug tracker for additional investigation.  Thanks for the report.

Tim - W4TME

Looks like this will be fixed in SmartSDR v1.4

pa0bie

Perhaps the same kind of problem.

I have severally times seen the radio frequencie changing when I used the RF Power slider during tuning the ATU.

Tim - W4TME

You should never change the power level when the internal ATU is tuning.  The ATU needs a constant power level.

pa0bie

Sometimes my FLEX do not show any power on the output display during tuning the ATU unless a raise the power slider. Also nothing on the SWR display.